DuttonOwners

Dutton Kit Cars and their owners

Anyone come across a heated manifold on a Pinto for a DGAS ,trying to find out where the wires connect to, there is a plug with two wires on one side   plus a single in the middle , all are on the underside    

Views: 50

Reply to This

Replies to This Discussion

Pictures?

I find it unlikely to be a heater, more likely to be an additional temperature sender. I assume it just goes into the water jacket not the air intake?

Its  got to be some sort of thermostat for something

Its a manifold heater. Quite common in the mid to late '80s. It comes on when the engine is cold and goes off once the coolant is up to temp. Helps to improve the emissions performance from cold. Since no pinto engine left the factory in europe/uk with a DGAS I suspect its the DMTL manifold adapted to take the DGAS - not difficult to do. Unless you're looking for good cold start emissions performance just ignore it.

Thanks BV

Sounds right - my CVH/Pierburg combo has this, but I believe not all did.

RSS

© 2017   Created by Tim Walker (The Bodger).   Powered by

Report an Issue  |  Terms of Service