DuttonOwners

Dutton Kit Cars and their owners

Jim (across the pond) Adamek's Discussions (307)

Search Forum

View

Discussions Replied To (228) Replies Latest Activity

"If I need the tool I think I will have to get it over there in the UK, I do not thin…"

Jim (across the pond) Adamek replied Dec 8, 2013 to Engine problems

 48 Dec 11, 2013
Reply by Jim (across the pond) Adamek

"Paul, the top of the carb has the oil cap on top. Is the adjustment down below the o…"

Jim (across the pond) Adamek replied Dec 8, 2013 to Engine problems

 48 Dec 11, 2013
Reply by Jim (across the pond) Adamek

"I suspected that there is an air leak somewhere but have not found it."

Jim (across the pond) Adamek replied Dec 8, 2013 to Engine problems

 48 Dec 11, 2013
Reply by Jim (across the pond) Adamek

"I purchased a set of two carbs to replace the single stromburg but they were in to b…"

Jim (across the pond) Adamek replied Dec 8, 2013 to Engine problems

 48 Dec 11, 2013
Reply by Jim (across the pond) Adamek

"There is a plastic plug on the bottom of of the fuel bowel but I do not see any adju…"

Jim (across the pond) Adamek replied Dec 8, 2013 to Engine problems

 48 Dec 11, 2013
Reply by Jim (across the pond) Adamek

"When depressing the lifting pin the engine dies."

Jim (across the pond) Adamek replied Dec 8, 2013 to Engine problems

 48 Dec 11, 2013
Reply by Jim (across the pond) Adamek

"Where is the acceleration pump located?"

Jim (across the pond) Adamek replied Dec 8, 2013 to Engine problems

 48 Dec 11, 2013
Reply by Jim (across the pond) Adamek

"The engine has a site draft stromberg carburater. I took off the top but did not see…"

Jim (across the pond) Adamek replied Dec 8, 2013 to Engine problems

 48 Dec 11, 2013
Reply by Jim (across the pond) Adamek

RSS

About

Tim Walker (The Bodger) created this Ning Network.
Create a Ning Network! »

© 2025   Created by Tim Walker (The Bodger).   Powered by

Report an Issue  |  Terms of Service