Photo 20-05-2014 18 09 50

Add a Comment

Comment by Paul Sheridan on May 21, 2014 at 9:44

I always tend to push Steve, I had a nice crackle going on and thats how I usually set the amps and feed. Think that I was being too hesitant and afraid of blowing a hole in the thin tubing. What sort of temperature should the thick metal be heated to ?

Comment by James Doulton on May 20, 2014 at 22:04

Presumably the bad bit is around the back because that looks pretty good to me.

Comment by Paul Sheridan on May 20, 2014 at 20:51

Can never quite get the hang of welding thin metal into thick metal !!   Try as I might, I cant get it to flow evenly, good job this wont be seen :-)