DuttonOwners

Dutton Kit Cars and their owners

20150401_165623

20150401_165623

Top seat belt anchors made for roll bar, out of the ever useful old side panels.

Rating:
  • Currently 0/5 stars.

Views: 48

View Full Size

Add a Comment

You need to be a member of DuttonOwners to add comments!

Join DuttonOwners

Comment by Paul Sheridan on April 1, 2015 at 19:42

Ah, I see. The original side panels on mine were stainless as well, and have now been used numerous times for various brackets, and I still have one and a half panels left.   

Comment by Paul Sheridan on April 1, 2015 at 18:36

No, not at all Daryl. if there was ever an impact with enough energy to pull that bolt through the stainless steel, there would not be enough of the car left to worry about it. Any way the weak part of the seat belt system in an S2 would be where the two buckle cables are bolted to the cross member under the floor of the boot, even though I have beefed it up, it is still a weak point.

About

Tim Walker (The Bodger) created this Ning Network.
Create a Ning Network! »

© 2025   Created by Tim Walker (The Bodger).   Powered by

Report an Issue  |  Terms of Service