Dutton Kit Cars and their owners
Today I am ..
Enjoying the sunshine, wiring the Sierra and buying stuff on ebay (again)
Despite having many big boxes full of odd nuts and bolts I don't seem to be able to find the coarse pitch UNF blots for the seat belts. M10 bolts thread into the holes but are so slack you can nearly wiggle them out
Are these bolts 3/4 UNF Cp or 5/8 UNF CP, does anybody know?
Add a Comment
-
Comment by Pete Clayton on June 11, 2014 at 21:22
-
In the end I found a 7/16 uhf bolt did screw in to one ok, a friend found a tap that size and they all just needed the threads running through to clean and de-rust. All good now!
-
Comment by Adrian Southgate on April 24, 2014 at 7:43
-
I bought some of evilbay, for the life of me can't remember the pitch and size of them though. I can always drop one out and measure up if needed.
-
-
Did you figure it out in the end Ade? like you an m10 screws in but is loose and the 7/16 unf ones I have are too fine for the threads. The build manual say 7/16 unf but its deffo not them
-
-
Oh to hell with it, I'm getting the cage out and replacing them with metric ones... pass the migwire lads..
-
-
just realised what i did there, dummy... How can someone my age forget how to measure a non metric bolt...
So I'll repeat the question so it makes sense.
Are dutton roll cage seat belt fixing bolts 3/4 UNC or 3/4 UNF
About
© 2024 Created by Tim Walker (The Bodger).
Powered by
You need to be a member of DuttonOwners to add comments!
Join DuttonOwners