DuttonOwners

Dutton Kit Cars and their owners

Legerra engine mounts Crossflow width vs pinto

My little 1300 crossflow sits very low in the engine bay the pully is so low I can't put my fat finger between the chassis and pulley. I'm sure the engine is nose down to which can't be good. Is this legerra built for a pinto?

Views: 63

Add a Comment

You need to be a member of DuttonOwners to add comments!

Join DuttonOwners

Comment by Dave Adams on February 21, 2015 at 7:18

It may have been ordered from the factory with Pinto mounts but built with a cross flow as they were always easier to find....(and way cheaper) the pinto also sits with the pulley just clear of the cross member. perhaps the mounts are the same?

© 2024   Created by Tim Walker (The Bodger).   Powered by

Report an Issue  |  Terms of Service