Angle iron fitted for four point harness

Add a Comment

Comment by James Doulton on August 8, 2014 at 23:05

That had me confused for a while until I realised that it was the Australian model. Like Daryl's!

Comment by neil parsons on August 8, 2014 at 22:56

today i fitted a large piece of checker plate to provide mounting points for the harness eyelets, The car has seat belts for the first time . It does not look pretty (yet) and a bit unique but it does the job.

Comment by Nick carlin on August 8, 2014 at 22:41

Mine was fitted before the body was put on from the top, I had to cut the rear rail then decided to make it this way.

Comment by Adrian Southgate on August 8, 2014 at 22:38

My tank drops down from under the chassis even with both rails in place.

Comment by Nick carlin on August 8, 2014 at 22:29

I modified mine so I can remove the tank. There is a piece of angle attached to the tank, and a nut welded to the angle so I can take the tank out easier :)

Comment by Adrian Southgate on August 8, 2014 at 22:25

Your'e some bits of metal missing back there.

There should be two lumps of angle going across that empty space to support the fuel tank