manifold

Add a Comment

Comment by Adrian Southgate on February 29, 2016 at 19:54

Get a fiesta four branch, cut off the collectors and reverse then so it comes out the side instead of under the engine.

Comment by Adrian Southgate on February 29, 2016 at 19:49

IF thats what you want to use then get it. If it doesn't fit MAKE it fit.

There is a company trading on ebay called hornet exhausts who will do a two silencer system in mild for £100. If you ask them nicely they will vary the contents of the kit to give you a Y piece and more 45 or 90 degree bends. make the pipe up on the car and then clamp it and take it off to have it seam welded up.

I know thats got to be done to XSC's four branch as it fouls the tub. I'm going with 4>2 and then two full length pipes under the car in smaller bore pipe.

Comment by Brian (up north) Morris on February 29, 2016 at 19:42

well if i but it i could cut it off and use some flexy to clear the tub....what you think..?  thanks

Comment by Steve Kerswell on February 29, 2016 at 19:40

Being serious, that is a generic crossflow aftermarket set of pipes, so yes it will fit your engine, but as Ade says may not fit your car. I have the same pipes on my Sierra and they fit.

Comment by Brian (up north) Morris on February 29, 2016 at 19:35

really i thought it was a fiat manifold...:-))))

Comment by Steve Kerswell on February 29, 2016 at 19:33

That's off a Ford crossflow Brian :-))

Comment by Brian (up north) Morris on February 29, 2016 at 19:25

any ideas what its off....thanks 

Comment by Adrian Southgate on February 29, 2016 at 19:18

Fit the engine? most likely... foul the front of the tub also most likely. I'd have to see it from a 'flat on the floor' angle to work out if its the same as mine but that second curve on the double pipe bit looks close to hitting the Dutton tub.

Comment by Brian (up north) Morris on February 29, 2016 at 18:40

god im quaking in my boots.... any ideas daryl

• ‹ Previous
• 1
• 2
• 3
• Next ›
• Page