DuttonOwners

Dutton Kit Cars and their owners

Mark Bagnall's Discussions (118)

Discussions Replied To (87) Replies Latest Activity

"The wheel bearing’s a good idea - although mine seemed ok not sure whether it would…"

Mark Bagnall replied Jul 3, 2018 to Camber correction

17 Oct 25, 2018
Reply by Nick carlin

"Ade, if you have a modified strut that’s close to the right height that would be gre…"

Mark Bagnall replied Jul 3, 2018 to Camber correction

17 Oct 25, 2018
Reply by Nick carlin

"Ade, that would be great, thanks, I’ll measure tomorrow. The right cast one must be…"

Mark Bagnall replied Jul 2, 2018 to Camber correction

17 Oct 25, 2018
Reply by Nick carlin

"The problems go a bit further - does anyone have a spare upright I could buy?  I hav…"

Mark Bagnall replied Jul 2, 2018 to Camber correction

17 Oct 25, 2018
Reply by Nick carlin

"Yes - pragmatic. I’ve disconnected some bits and the inner tca mount is a couple of…"

Mark Bagnall replied Jul 1, 2018 to Camber correction

17 Oct 25, 2018
Reply by Nick carlin

"Hi Daryl. I had wondered about them so had a look back through old posts.  I will ha…"

Mark Bagnall replied Jul 1, 2018 to Camber correction

17 Oct 25, 2018
Reply by Nick carlin

"Crank and block now at Bradbury Engineering - I'm optimistic they seem to know there…"

Mark Bagnall replied Jul 20, 2017 to Crossflow engine rebuild

1 Jul 20, 2017
Reply by Mark Bagnall

"Sold to a car enthusiast to take the place of a completed project so hopefully anoth…"

Mark Bagnall replied Jan 7, 2017 to Malaga B+

7 Jan 7, 2017
Reply by Adrian Southgate

"Hi Dave, the tube was just tacked on as a datum when I was measuring up."

Mark Bagnall replied Nov 21, 2016 to Malaga B+

7 Jan 7, 2017
Reply by Adrian Southgate

"Hi James, a few bits but not a large section."

Mark Bagnall replied Nov 21, 2016 to Malaga B+

7 Jan 7, 2017
Reply by Adrian Southgate

RSS

© 2024   Created by Tim Walker (The Bodger).   Powered by

Report an Issue  |  Terms of Service