Hi all,
I have cut a section out of one of the chassis rails so the type 9 box will fit. I have drilled through the rail either side and bolted the mount up, see below
Obviously I now need to put some strength in. I am planning on welding another rail in behind the existing one and then tieing the original one in to it like so. Excuse naff drawings!
Will this be sufficient? I have some 40x40x2.5 box to use
Tags:
That looks like a good idea. Dont forget to think about how you will take the box out (if needed) Engine out then Gearbox or Engine and Box in one lump. Now is the time to think about these things. :-)
Going to order some angle iron this evening so I can sort the box mount. I am looking at 40mm x 40mm same as the box and 3mm thick, will that be sufficient or should I go 5mm?
I know the box section has thinner walls but wasn't sure the L shaped angle iron would be as strong hence planning on getting thicker
© 2025 Created by Tim Walker (The Bodger). Powered by